Installation of Glass lined Reactor

1. Handling: Only the ear of the can is allowed to be subjected to force during handling (referring to non packaging), and rolling or using pry bars is not allowed to avoid vibration and collision. It is strictly prohibited to take over vulnerable parts such as pipe clamps and clips for force.
2. Lifting: During lifting, wire ropes must be hung at designated locations (such as jacket connections, tank ears, etc.). The lifting ring on the tank cover is only used for lifting the tank cover. It should not collide with any objects and should be lifted and placed gently.
3. Pre assembly inspection: Before assembly, inspectors should wear clean soft soled rubber shoes and enter the container to check for any abnormalities in the enamel layer.
4. Installation of flange: When tightening the flange bolts, they should be gradually tightened in pairs along the diagonal, with even force and not completely tightened at once, to avoid the rupture of the enamel layer caused by uneven force and affecting its service life.
5. Installation of clips: First, check whether the clips are complete and whether the quantity meets the regulations. During installation, ensure that the distance is equal, the elasticity is moderate, and ensure safe operation and reliable sealing.
6. Installation of agitator: a. First, put the agitator into the tank (with a soft pad laid at the bottom of the tank), then lift the tank cover to the predetermined position, and at the same time, insert the seal into the mixing shaft. Then, lift the agitator and connect it to the output shaft of the reducer, and lock the anti loosening device. b. Adjust the coaxiality and verticality between the mixing shaft and the sealing element to meet the technical requirements. Slowly rotate the mixing shaft until it runs smoothly and without any abnormalities. Only then can the motor button be turned on again until it runs normally (this period should not be too long).
7. Selection of gaskets: The selection must be based on the type, concentration, and temperature of the medium. The properties and usage methods of the gaskets themselves should be suitable for the process requirements. Our company provides gaskets with asbestos rubber and rubber wrapped polytetrafluoroethylene for users to choose from.
8. Welding: a. It is strictly prohibited to weld on the surface of the outer wall of the enamel glass jar.
b. When welding pipes, tank ears, and tank seats on the jacket, electric welding should be used and cooling measures should be taken. Gas welding is absolutely not allowed.
c. When welding near the space of the enamel layer, the surface, tank mouth, and pipe mouth of the enamel layer should be tightly covered to avoid welding slag splashing and damaging the enamel surface.